When a 100 GbE QSFP28 port is configured for SR4 breakout, the host may see the link as four independent 25 Gb lanes or as a single 100 Gb native lane. The first step is to verify which mode the transceiver reports in its DOM (Digital Optical Monitoring) registers – a “Mode” field typically shows 0x00 for native 100G LR4/LR4 and 0x02 for 4×25G breakout. If the host expects breakout but the DOM reports native, the host will not map the four lanes correctly and may show intermittent loss of traffic on one or more lanes.

Next, confirm the MPO connector type. SR4 uses MPO‑Type B (Polarity B) with a standard lane‑to‑lane mapping. A mismatch (e.g., Type A cable) will cause one or more lanes to be swapped, leading to asymmetric Rx power readings. Check the per‑lane Rx power in the DOM; typical SR4 Rx values are –5 dBm to –2 dBm at 10 km. A lane reading significantly lower than the others (e.g., below –8 dBm) often indicates a connector polarity issue or a bad fiber.

Finally, verify the host’s breakout configuration. The NIC or switch must be set to “4×25G” mode; otherwise the driver may enforce lane‑masking that drops traffic on mismatched lanes. After adjusting the mode and confirming correct MPO polarity, the link should stabilize across all four lanes.

What diagnostic steps have you found most reliable for confirming correct MPO polarity and breakout mode on a 100 GbE SR4 link?